This kit does NOT fit a WJ, only a WJ swapped knuckle on the models listed, as the bar is too short for a WJ.
Have you made the swap to WJ knuckles but need a steering solution? Well...you've found it. CavFab has taken over the steering market by offering the most cost effective products, period. As with our normal CrossOver steering system this requires drilling your knuckles and pitman out to accept the larger 5/8" hardware, beyond that this is a 100% bolt on upgrade! If you are unfamiliar with the WJ knuckle swap it entails swapping the stock knuckles to knuckles from a 99-04 Jeep Grand Cherokee. This has many benefits such as a raised drag link mount on the knuckle for flatter steering angles, independent tie rod / drag link mounts on the knuckle to lessen the stress as opposed to the factory knuckles, and the ability to run the much larger dual piston WJ brake setup.
1.5" SOLID Tie Rod & Drag Link!
Heat Treated 3/4" Chromoly Heim Joints
Superior CavFab Craftsmanship
High Clearance Design
NO BS WARRANTY
Requires Minimal 3" Of Lift
Ships Raw Steel (Powder Coating Optional)
**THIS IS FOR JEEPS WITH THE WJ KNUCKLE SWAP, IF YOUR JEEP HAS FACTORY KNUCKLES, YOU CANNOT RUN THE ORIGINAL CAVFAB CROSSOVER STEERING ON THIS SET UP, AS THE DRAG LINK AND TIE ROD ARE DIFFERENT SIZES
***IF YOU HAVE FACTORY KNUCKLES AND YOU ARE LOOKING FOR A STEERING SYSTEM THEN PLEASE CLICK HERE**