1 Ton Drag Link - (JK/JKU)

Be sure to check out our Current Lead Times before purchase.
Our 1 Ton JK Bolt On HD Drag Link is a direct factory replacement, no drilling or reaming required, simply remove the old one, and install our new one! The Factory Drag Link on the JK is simply not up to the task of holding up to larger tires. The drag link sees a lot of force turning large tires on and off-road, causing it to be susceptible to buckling or bending. Also, being that the drag link is the connector between your steering gear box and axle, a failure will leave you stranded on the trail. Finally, the factory tie rod ends on the JK will wear pre-maturely leading to poor steering and even Death Wobble. Our HD Drag Link System replaces the entire drag link with a heavy duty system designed and manufactured here in house. We use SOLID 1.5" 1045 Alloy Steel which is exponentially stronger than the factory material used. Our HD Drag Link System is able to take the force of turning large tires on the street or trail without the fear of bending. Our 1 Ton Tie Rod Ends are much larger than the factory tie rod ends, and are directly greaseable via a zerk fitting (Be sure to keep these well maintained/properly greased for maximum life). These will provide the most quiet and factory like steering characteristics. As always this product is backed by the CavFab NO BS Warranty.
  • Fits all 07 - 18 Jeep Wrangler JK and JKU
  • Direct Bolt On! No Drilling, Reaming or Cutting!
  • Manufactured from 1.5" SOLID 1045 Alloy Steel (Not hollow DOM like the competition) 
  • Designed, Engineered, Tested, and Built here in the USA
  • Ships Raw Steel, ready to be coated (Satin Black Powder Coat Option Available)
  • Includes all required hardware needed for installation
  • Designed to work with the stock axle side track bar / Stabilizer mount (Aftermarket track bar mounts may not work)
  • Not compatible with the Fox or Falcon ATS Stabilizers (Through Shaft). Compatible with all stabilizers.
*We recommend this kit be installed with aftermarket wheels, the factory 17" JK wheels to not have a sufficient backspacing to allow for the larger rod ends to clear. A wheel with 4.75" Backspacing or Numerically less. If you run factory wheels with a 1" or larger wheel spacer this will suffice also** If you have any questions about fitment with a particular wheel, feel free to contact us for assistance.

*We also offer the drag link in 7075 aluminum!

*Due to supply chain issues, the rod ends in this kit may not be from the same supplier and may have minor visual differences between one another*